AOpen 4-Port 10/100Mbps Ethernet Broadband Router Guía de usuario

2 FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. T

15 INTERNET BROADBAND ROUTER CONFIGURATION First, make sure that the network connections are functioning normally. This Internet Broadband Router can

17 1-2-1 Dynamic IP (Cable Modem) To connect to a Dynamic IP (Cable Modem) Internet connection with the Broadband Router, check the cable modem with t

19 control the connection time (default time=0, always connect). Check the Connect-on-demand box to enable your router to connect your ISP whenever an

21 2-1-3 Firmware Upgrade Upgrading firmware for this Broadband Router improves functionality and performance. Enter the path and name of the upgrade

23 2-1-7 Reset 2-2 WAN The Broadband Router supports the following types of Internet connections: Dynamic IP Address, Static IP Address, PPPoE, and

25 The MTU feature specifies the largest packet size permitted for network transmission. Enter the value desired; for most DSL users, 1492 is recommen

27 Enter the username provided by your Dynamic DNS service provider. • Password Enter the password provided by your Dynamic DNS service provider. 2-3

29 Specifically, UDP doesn't provide sequencing of the packets that the data arrives in. This means that the application program that uses UDP mu

31 2-5 Firewall The Broadband Router provides extensive firewall protection by restricting connection parameters to limit the risk of hacker attacks

33 2-5-4 DMZ (Demilitarized Zone) If a local client PC cannot run an Internet application properly from behind the NAT firewall, open the client up to

TABLE OF CONTENTS About This Guide...1 Pu

35 LIMITED WARRANTY TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following length

37 OF THE PURCHASE PRICE PAID, AT TRENDNET’S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL

1 ABOUT THIS GUIDE Congratulations on your purchase of this Cable/DSL 4-port Broadband Router. This device integrates 100Mbps Fast Ethernet and 10Mbps

3 INTRODUCTION With the explosive growth of the Internet, accessing information and services at any time, day or night, has become standard fare for m

5 UNPACKING AND SETUP This chapter provides unpacking and setup information for the Broadband Router. Unpacking The box should contain the following i

7 HARDWARE INSTALLATION Front Panel The figure below shows the front panel of the Broadband Router. 4-Port 10/100Mbps Ethernet Broadband Router Front

9 Hardware connections Connect the Internet Broadband Router 1. Connect one end of the network cable to the WAN port of the 4-port Internet Broadba

11 PC NETWORK TCP/IP SETTING The network TCP/IP settings differ based on the computer’s operating system (Win95/98/ME/NT/2000/XP) and are as follows.

13 Windows XP/2000 1. Right click My Network Places and select Properties 2. Double-click on the Local Area Connection icon and click Properties. 3