AOpen MP65-D Manual de usuario descargar pdf (Pagina 38)

To upgrade to the i-Vu Pro v6.0 application

Custom Control Programs

• If you have custom logic created in EIKON that is being used as a part of the control sequence, you cannot

replace the custom control program with the automatically-generated one.

• Your EIKON-created control program will still run in an i-Vu Integrator that has been upgraded to run with the

i-Vu Pro v6.0 application.

• In order for a custom control program to support any of the new features available in the i-Vu Pro v6.0

application, it is necessary to apply an update to EIKON under the i-Vu Pro v3.1 application.

To apply the EIKON update:

1 Download the update file called

iv42_eikon.update

from the Service Intranet.

2 Open SiteBuilder v3.1.

3 Select

Actions

Apply Update.

4 Browse to the location of the .update file and select it.

5 The screen should appear as seen below. Click

Apply

to apply the EIKON patch.

• You will need to use the EIKON program that was a part of your i-Vu Pro v3.1 system to edit any custom

control programs.

NOTE

Custom programs created with EIKON will only run in an i-Vu Integrator. They are not supported in i-Vu

CCN Routers.

Local override

• Local overrides were not allowed in the i-Vu Pro v3.1 application.

• Control programs that are automatically generated during the discovery process in the i-Vu CCN Pro v4.2

application will support local overrides.

• To support new features in an EIKON-generated control program, you need to make some small changes.

○ v3.1 control programs typically had a section like the one shown in Figure 1. This took the current

schedule state and used a Carrier Schedule Write microblock to write it to a CCN device. This should be

replaced with logic similar to that shown in Figure 2.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Sin comentarios

AOpen MP65-D Manual de usuario Pagina 38