AOpen AOI-702U Especificaciones descargar pdf (Pagina 14)

Inspecting a PCB

To start inspecting a PCB, first observe the caption bar of the main window to

verify that the correct board setup is loaded. If so, you may start the inspection

process by selecting Test Board from the File Menu. (or by pressing the

button on the tool bar) The system moves to the load position and then the

following dialog will appear to prompt the user to load in a PCB for inspection:

There is one Check box, Enter Board Serial Number. If the check box is

checked, the software will prompt the user to manually enter a board serial

number when the OK button on the “Load untested PCB for inspection” dialog

is pressed. If this box is not checked, the system will automatically assign a

default board name and a sequence number to the board. The small Set

button launches a dialog for changing the board’s sequence number count

and other parameters.

If the barcode reader option is installed, or Image barcode reading is enabled

and correctly setup, the system will automatically read the bar-code of the

board.

The inspection process starts after the user presses the OK button in this

dialog or the START button on the system.

For the in-line version of the system, the inspection process starts

automatically when the board on the conveyor is detected by the board

sensor.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 133 134

Sin comentarios

AOpen AOI-702U Especificaciones Pagina 14