AOpen AOI-702U Especificaciones descargar pdf (Pagina 51)

FA Inspector (AOI) Scanner

51 | Page

FocalSpot, Inc. | www.FocalSpot.com

3. Load a PCB in the center of the table at (15, 20 or 25mm) stand-off height.

Best Practice: Always use the 20mm stand-off position whenever possible, as this position provides

the best focus and lighting. Maximum component clearance is 70mm at the 20mm setting.

4. Press the <15mm, 20mm or 25mm > calibration button in the File Selection/Calibration Screen that

matched the stand-off position used when the board was loaded (15, 20 or 25mm).

5. The AOI Mode Display Screen will now open in the default Operator Mode.

Note: You will need to change to Supervisor Mode to create a new inspection routine. Supervisor

Mode provides full access to development and management functions; including all of the Operator

Mode functions. Users are required to provide a password to enter Supervisor Mode.

Note Also: Multiple user accounts can be configured if operator tracking is required. See also, User

6. To enter Supervisor Mode select <File / Go to Supervisor Mode>, when prompted <Enter the

Supervisor Password>, the default password is: “focalspot”. See, Supervisor Mode for menu item

definitions.

Go to Supervisor Mode Check Password Dialog Box

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 164 165

Sin comentarios

AOpen AOI-702U Especificaciones Pagina 51