AOpen AOI-702U Especificaciones descargar pdf (Pagina 71)

FA Inspector (AOI) Scanner

71 | Page

FocalSpot, Inc. | www.FocalSpot.com

7. Next press the <PCB Alignment Button> located on the AOI Top Menu Bar.

8. You may now use the Reference IDs on the Layout Viewer Display of the Assembly Drawing to confirm

the location of each of the (3) three devices used to define the CXF to scanned PCB image scale and

alignment when asked in the following steps.

Note: The following steps are the same as those used If REF IDs were screened onto the PCB. Assuming

that you have already created a <New Board Setup> up to and through the steps of Defining Board Size

and Alignment Points in the previous section, “Creating an AOI Mode Inspection Routine”. Continue to

the next steps to complete this process using the Layout Viewer tool to guide you through identifying the

correct Device IDs.

9. CXF to PCB alignment prompts will appear directly after a new board has been started and the size and

PCB alignment marks have been defined. At this point the system will display a <Confirm/Adjust Device

Position> dialog box displaying the (1

, 2

and 3

) alignment device in turn by REF ID, starting with the

lower-left location.

Defining 1 of 3 XY to PCB Alignment Devices

10. Locate the 1

component by “Device ID:” shown in the Device Position dialog box.

11. Move the Green Box to the center of the device using the mouse (drag-&-drop).

12. Next, use the keyboard <Left-Ctrl Key> in combination with the <Arrow Keys>, (<Left-Ctrl Key>+<Arrow

Keys>) to adjust the height and width of the Green Box so as to match the height and width of both pads

for the selected device.

Best Practice: The Keyboard Arrow Keys can also be used to adjust the location of the Green Box. To

do this (do not hold down the Ctrl Key), use only the Arrow Keys to move the box up, down, left or right.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 164 165

Sin comentarios

AOpen AOI-702U Especificaciones Pagina 71