AOpen AOI-702U Especificaciones descargar pdf (Pagina 82)

Operations | Reference Manual

FocalSpot, Inc. | www.FocalSpot.com

Page | 82

11. Once a test is initiated, the system will prompt the user to stage a PCB into inspection area using the

appropriate stand-off height. Press the <Scanner Setup> button and follow the scanner setup

instructions for creating a new program.

Load Untested PCB for Inspection

12. If Automatic Alignment fails, first verify that the board is loaded correctly. If you are certain that the

board is loaded correctly and positioned in the proper location on the table grid; you can manually –re-

identify the first alignment point by double-clicking to the alignment location, then press the <Override>

button.

Board Aligned to Selected Point Alignment Error

13. Once the automatic alignment is satisfied; the Inspection will automatically begin and upon completion

report the results by displaying a Pass or Fail PCB Inspection Result dialog box. NOTE: If this results

in an Alignment error, the following error message will appear. Move the stage to the correct position

and magnification and press retry if this fails, press override.

14. The inspection will now continue unattended until finished.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 164 165

Sin comentarios

AOpen AOI-702U Especificaciones Pagina 82